1 x Naza-M Lite multi-axis control
1x GPS module DJI
1 x Naza BEC
1x Naza lite LED Module
1 x Wire servo connector
1 x USB Cable
New Naza lite with module led and Bec
NAZA LITE is a lightweight multi-axis control platform specially designed for aeromodel hobbyists. It is a smalled all-in-one module includes controller, gyroscope, accelerometer and barometer. It has D-Bus support, upgrade support, and extendible port.
Different Naza LITE from from Naza V1 / Naza V2: Naza Lite, not extension ability (not support PMU Naza V.2, Zenmuse H3-2D, GPS Bluethoo, IOSD, etc.., independet assistant software and firmware, GPS Optional.
Naza Lite also provides excellent maneuverability, which gives hobbyists wonderful flight experience.
- Auto Level Fail-safe
- Low Voltage Protection
- S-Bus Receiver Support
- 2-axle Gimbal Support
||Supported ESC output
||Working Voltage Range
|Quad-rotor I4, X4 / Hex-rotor I6, X6, IY6, Y6
||400Hz refresh frequency
||PCM or 2.4GHz with minimum 4 channels
VU: 7.2V ~ 26.0 V (recommend 2S ~ 6S LiPo)
||Assistant Software System Requirement
|MAX1. 5W (0.3A@5V)
|-10°C ~ 50°C
||Windows XP sp3 / Windows 7 / Windows 8
|Max Yaw Angular Velocity
||Max Tilt Angle
||Ascent / Descent
|MC: 45.5mm x 31.5mm x 18.5mm
VU: 32.2mm x 21.1mm x 7.7mm
GPS & Compass 46mm(diameter)x9mm
|Three Modes Autopilot
Low Voltage Protection
S-Bus Receiver Support
2-axle Gimbal Support
All-in-One designAll- in-One Design integrates inner damping, controller, gyroscope, accelerometer and barometer, which simplifies installation and saves space.
Advanced attitude stabilization algorithm- Advanced mix guidance algorithm and control algorithm, inherits outstanding flight stability of DJI products, provides excellent maneuverability, gives hobbyists wonderful flight experience.
Multiple Flight Control Mode- GPS Atti. Mode (with GPS module), Atti. Mode, Manual Mode. The pilot can switch between the three modes to achieve different flight characteristics.
Intelligent Orientation Control (IOC)- Usually, the forward direction of a flying multi-rotor is the same as the nose direction. By using Intelligent Orientation Control (IOC), wherever the nose points,the forward direction has nothing to do with nose direction
Low voltage protectionTwo- Level low voltage protection. low voltage LED alarm, and automatic landing.
Fail Safe- If your transmitter supports failsafe, then you can set failsafe through port-U. Naza controller has built-in auto level failsafe function, which means when the communication between MC and the transmitter is disconnected, the outputs of all command sticks from controller will go to center position. If the GPS module is used, you can also set RTH on failsafe.
D-BUSD- Bus supports S-BUS and PPM receiver system
2-axis Gimbal Stabilization- The gimbal stabilization module is compatible with almost all 2-axis gimbal systems. The system will adjust the gimbal and camera according to the attitude of the helicopter after setting the parameters the first time.
Remote Adjustment- The default parameter settings are OK for you to achieve a normal flight, and it also supports remote parameter adjustment by using a control slider on the TX during flight, in order to obtain better performance.
Upgradeable and extendible- Easy firmware upgrade, extendible port for future use is available.
Support & Download
• Support & Downloads: Videos, Manual, Firmware, Driver, Notes, Tutorial, FAQ