Inicio My Account  Cart Contents  Checkout  
  Top » Catalog » R/C Products » RC Transmitter & Rx » Receivers » FrSky TFR8SB My Account  |  Cart Contents  |  Checkout   
Categories
 ROV Dron Under Water
 Sales DJI
 DJI Innovations Products   DJI Goggles    DJI Promotion    Tello    Spark    Mavic 2    Mavic 2 Enterprise    Mavic AIR    Mavic Pro & Platinum    Phantom 4 Advanced    Phantom 4 RTK    Phantom 4 Pro    Phantom 4 Pro Obsidian    Phantom 3    Inspire 1    Inspire 2    Matrice 600 / 100 / Guidance    Matrice 200 / 210 / 210 RTK    CrystalSky    DJI Wind Series    Osmo    Osmo Pocket    Ronin & Focus    S1000, S900, S800    F450 / F550    A3 / A2 / N3 / Naza    LightBridge 2    Telemetry & Video    Power Systems    Z15 / H33D / H43D    Phantom 1 & 2    DJI Care
 Multicopter   Multicopter Combo (RTF)    Frame Multirotor    Flight Controller    Brushless Motors    Speed Control (ESC)    Proppeller    Landing Gear    Fly Simulator    Flight Case    Accessories    Fiber, Carbon, tube,..
 Parachutes
 Gimbal   Frame & Parts    Gimbal Combo    Gimbal RTF    Electronic    GMB Motors    Gimbal with servos
 Micro Dron   FatShark Video Goggles    Micro BackPack    Micro Battery    Micro ESC    Micro Flight Control    Micro Frames    Micro Motor    Micro Power Set    Micro Proppeller    ImmersionRC Vortex 285    ImmersionRC Vortex 250    Micro accesories    Tramp HV 5.8Ghz
 Connex HD Video DownLink
 Thermal & Multispectral Cammeras
 Cable Cam
 FPV/RPV & UAVīs   FatShark Goggles    FatShark Accessories    Video Monitor    Camera    Video Tx & Rx    Set FPV    OSD / AutoPilot    Telemetry-GPS    Antenna    Antenna Tracking Systems    433Mhz Long Range    Pan & Tilt / HT    Plane Cockpit    Accessories
 R/C Products   Plane    Chargers    RC Transmitter & Rx    Servos    Motor / ESC / Prop    Electronic Circuit    Conectors & Adapters    Wire    Heat Shrink Tubing    Fly Simulator    Hardware    Tools
 Lipo Baterys   Bateries RC TX    Lipo Batteries 2S    Lipo Batteries 3S    Lipo Batteries 4S    Lipo Batteries 6S    Connectors    Lipo accesories
 Li-Ion Battery   Single Cells    Li-Ion Battery 3S    Li-Ion Battery 4S    Li-Ion 8S Battery    Li-Ion Battery 6S
 UgCS Software
 Droens Services
 Flight Case
 RPA Pilot Course (Drones)
 Clearance
 Sale
FRSKY TFR8SB 8/16CH Rx 2.4G Compatible Futaba Sbus+RSS
[FrSky TFR8SB]
46.00EUR




                            FrSky 8/16ch FASST compatible (Futaba) receiver 8/16CH with SBus and RSSI enabled

1. Introduction

1.1.1 Compatible systems

FASST 2.4GHz Air Systems (7CH Mode/Multi Mode): 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc.

1.1.2 Compatible servos at SB port

Futaba S.BUS servos, FrSky S Bus compatible servos D12MB

Model: TFR8SB (8CH FASST compatible receiver with RSSI & SB ports)

Channel: 8/16 Ch

Dimension: 44.5*27.5*17mm

Weight: 11.5g

Operating Voltage Range: 3.5~10V

Operating Temperature Range: -10~80

Servo Frame Rate: 14ms (FS – Normal Speed Mode)

7ms (HS – High Speed Mode)

MANUAL

1.3 Features

1) Compatible with FASST 2.4GHz Air Systems (7CH Mode/Multi Mode)

2) SB port is compatible with Futaba S.BUS servos and FrSky S Bus compatible servos

3) With RSSI output

4) Two selectable failsafe setting options (use native failsafe on radio side or set failsafe on TFR8SB side)

5)S.BUS servos/S Bus compatible servos channel setting channel setting on TFR8SB

6)Improve sensitivity and stability

7)Wider and higher operating temperature range, suitable for all kinds of models

8)Firmware upgradeable




2.1 Bind procedure

Turn on the transmitter, connect the battery to the receiver while pressing receiver's F/S button. After the RED LED is off and GREEN LED is solid, the binding process is completed and the receiver is operating

2.2 Setting failsafe

TFR8SB support two selectable failsafe setting options, either use native failsafe position preset on the transmitter side, or set failsafe on TFR8SB.

2.2.1 Use native failsafe position preset on the transmitter side:

If not disabling failsafe on the transmitter side, TFR8SB will use native failsafe position preset on the transmitter side.

2.2.2 Set failsafe on TFR8SB side:

TFR8SB supports failsafe function for all channels. Follow the steps below to set failsafe on TFR8SB:

1) Bind the receiver first, and disable failsafe on the transmitter side;

2) Set all transmitter controls to the desired failsafe position;

3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating the failsafe is

set up successfully.

I f you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.

 

2.3LED status

RED LED

GREEN LED

Mode

Off

On

Normal mode

On

On

Waiting to be bound

Flashing

On

Signal lost

On

Flashing twice

Set failsafe

Flashing slowly

On

Normal speed mode

Flashing fast

On

High speed mode



3. How to switch between two PPM modes

Turn the transmitter off, connect the battery to the receiver, press the F/S button of receiver for 6 seconds and then release. The red LED will flash fast in HS Mode and slow in FS Mode. Repeat this to alternate modes.

Note: HS mode is only applied for high-speed digital servos. Other servos should select FS mode, otherwise servos will get hot or even burn out.

4. Channel Setting Methods

Channel setting for Futaba S.BUS servos and FrSky S Bus compatible servos can be performed at TFR8SB.

1, Connect the SB port and RSSI port by the provided cable.

2, Connect an S.BUS servo or S Bus compatible servo to the output connector (1~8) corresponding to the channel you want to set.

Output Connector

Channel Setting

Mode A

Mode B

1

1

9

2

2

10

3

3

11

4

4

12

5

5

13

6

6

14

7

7

15

8

8

16

3, Connect battery to the receiver, RED blinking LED indicating the channel setting is completed in Mode A. To switch to Mode B, press the button on receiver for three seconds until GREEN LED starts to blink, indicating the channel setting is completed in Mode B.

Mode A: RED LED blinks

Mode B: GREEN LED blinks

Note: Do not perform linking procedure while motor's main wire is connected or engine is operating, otherwise damage may occur. After linking is completed, recycle the receiver power and check if the receiver is really under control by linked transmitter.




 






This product was added to our catalog on Sunday 26 January, 2014.
Reviews
Customers who bought this product also purchased
Velcro (5 pcs) backed foam kit for FatShark face plates
Velcro (5 pcs) backed foam kit for FatShark face plates
Vortex 250 PRO<b> UMMAGAWD </b>350mW ARF, Zipper Case Packaging
Vortex 250 PRO UMMAGAWD 350mW ARF, Zipper Case Packaging
Gens Ace 1300mAh 11.1V <b> 45C </b> 3S1P Micro Race Battery Pack
Gens Ace 1300mAh 11.1V 45C 3S1P Micro Race Battery Pack
Gens Ace 1300mAh 11.1V <b> 75C </b> 3S1P Micro Race Battery Pack
Gens Ace 1300mAh 11.1V 75C 3S1P Micro Race Battery Pack
Gemfan 5x4.5" Propeller Black <b>Total 8 pcs </b> (4 CW + 4 CCW)
Gemfan 5x4.5" Propeller Black Total 8 pcs (4 CW + 4 CCW)
Signal Loss Alarm& Lost Aircraft Finder (SkyRC)
Signal Loss Alarm& Lost Aircraft Finder (SkyRC)
Shopping Cart more
0 items
Manufacturer Info
Other products
Notifications more
NotificationsNotify me of updates to FRSKY TFR8SB 8/16CH Rx 2.4G Compatible Futaba Sbus+RSS
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
Tell A Friend
 
Tell someone you know about this product.
What's New? more
<b> Osmo Pocket Cable Cam </b>
Osmo Pocket Cable Cam
139.00EUR
Manufacturers
Languages
English Espaņol
Currencies
Information
Financing
Shipping & Payment
Privacy
Conditions
Contact us
Site Map
RMA (Returns to SAT)

Copyright © 2019 ElectronicaRC.com
Powered by osCommerce

Shipping