|
FrSky 10ch FASST compatible (Futaba) receiver with CPPM and RSSI enabled
TFRSP has Combined PPM for CH1 to CH9 servo signal for CH5 to CH10 and RSSI (received signal strength indicator) output.
CPPM is usable for reducing the wiring to some, Multicopter controller, Autopilot systems (go home) for FPV planes, UAV systems, flybar-less controllers
Furthermore it could be used as a wireless trainer/simulator connection similar to the Futaba WTR-7.
1.1 Compatibility:
Futaba: 6EX, 7C, TM-7, TM-8, T8FG, T10C, TM-10, T10CG, T12Z, T12FG, TM-14, T14MZ, etc
FASST 2.4G: Air Systems (7CH Mode/Multi Mode)
FrSky TF Modules: TF-8M TF-14M
1.2 Specifications TFRSP:
Number of Channels: up to 10 channels (CPPM for CH1~CH9 servo signal for CH5~CH10)
With RSSI Output
TFRSP supports failsafe function for all channels
Operating Voltage Range: 3.5V~10V
Moduladion: 2,4Ghz, ACCST
Operating Temperature Range: -10℃~60℃ Dimension: 53mm*30mm*11mm Weight: 13.5g
Manual
  Warning: Servos are not to be plugged into Channel CPPM and Channel RSSI otherwise servos will get hot or may burn out.
2.1 Bind procedure:
Turn on the transmitter connect the battery to the receiver while pressing receiver’s F/S button. After the RED LED is off and GREEN LED is solid the binding process is completed and the receiver is operating normally.
2.2 Setting failsafe:
TFRSP supports failsafe function for all channels. Follow the steps below to set failsafe:
1) Bind the receiver first and disable failsafe on the transmitter side;
2) Set all transmitter controls to the desired failsafe position;
3) Press briefly the F/S button of the receiver the GREEN LED of the receiver will flash twice indicating the failsafe is set up successfully.
If you do not need the failsafe function any more just re-bind the receiver to set default failsafe mode.
Warning: Some transmitter manufacturers use a failsafe method that can interfere with that used by FrSky. Be sure to disable any transmitter failsafe settings before setting FrSky failsafe positions. Unusual jitter may result otherwise.
2.3 LED status:
| RED LED |
GREEN LED |
Mode |
| Off |
On |
Normal mode |
| On |
On |
Waiting to be bound |
| Flashing |
On |
Signal lost |
| On |
Flashing twice |
Set failsafe |
|
50% OFF
DJI Goggles
