Inicio My Account  Cart Contents  Checkout  
  Top » Catalog » R/C Products » RC Transmitter & Rx » Receivers » FrSky D8R-XP My Account  |  Cart Contents  |  Checkout   
Categories
 BLACK FRIDAY
 ROV Dron Under Water
 Sales DJI
 DJI Innovations Products   DJI Goggles    DJI Promotion    Tello    Mavic Mini    Spark    Mavic 2    Mavic 2 Enterprise    Mavic AIR    Mavic Pro & Platinum    Phantom 4 Advanced    Phantom 4 RTK    Phantom 4 Pro    Phantom 4 Pro Obsidian    Phantom 3    Inspire 1    Inspire 2    Matrice 600 / 100 / Guidance    Matrice 200 / 210 / 210 RTK    CrystalSky    DJI Wind Series    Osmo    Osmo Pocket    Ronin & Focus    S1000, S900, S800    F450 / F550    A3 / A2 / N3 / Naza    LightBridge 2    Telemetry & Video    Power Systems    Z15 / H33D / H43D    Phantom 1 & 2    DJI Care
 Multicopter   Multicopter Combo (RTF)    Frame Multirotor    Flight Controller    Brushless Motors    Speed Control (ESC)    Proppeller    Landing Gear    Fly Simulator    Flight Case    Accessories    Fiber, Carbon, tube,..
 Parachutes
 Gimbal   Frame & Parts    Gimbal Combo    Gimbal RTF    Electronic    GMB Motors    Gimbal with servos
 Micro Dron   FatShark Video Goggles    Micro BackPack    Micro Battery    Micro ESC    Micro Flight Control    Micro Frames    Micro Motor    Micro Power Set    Micro Proppeller    ImmersionRC Vortex 285    ImmersionRC Vortex 250    Micro accesories    Tramp HV 5.8Ghz
 Connex HD Video DownLink
 Thermal & Multispectral Cammeras
 Cable Cam
 FPV/RPV & UAV´s   FatShark Goggles    FatShark Accessories    Video Monitor    Camera    Video Tx & Rx    Set FPV    OSD / AutoPilot    Telemetry-GPS    Antenna    Antenna Tracking Systems    433Mhz Long Range    Pan & Tilt / HT    Plane Cockpit    Accessories
 R/C Products   Plane    Chargers    RC Transmitter & Rx    Servos    Motor / ESC / Prop    Electronic Circuit    Conectors & Adapters    Wire    Heat Shrink Tubing    Fly Simulator    Hardware    Tools
 Lipo Baterys   Bateries RC TX    Lipo Batteries 2S    Lipo Batteries 3S    Lipo Batteries 4S    Lipo Batteries 6S    Connectors    Lipo accesories
 Li-Ion Battery   Single Cells    Li-Ion Battery 3S    Li-Ion Battery 4S    Li-Ion 8S Battery    Li-Ion Battery 6S
 UgCS Software
 Droens Services
 Flight Case
 RPA Pilot Course (Drones)
 Clearance
 Sale
FRSKY D8R-XP. 8 two way comunication Ch8 RX 2.4Ghz W/ TELETRY, P
[FrSky D8R-XP]
33.00EUR




FrSky D8R-XP8 Channel Receiver w/ telemetry, PPM output

Compatible with FrSky two way telemetry modules: DFT, DJT, DHT, DHT-U

Specification:

Dimension: 55*25*14mm
Weight: 12.4g
Operating Voltage Range: 3.5V-10.0V
PPM Output
Operating Current: 100mA
Operating Range: 1.5-2.5 km
Resolution: 3072 (>11bit)
Servo Frame Rate: 18ms (FS – Normal Speed Mode)
                                 9ms (HS – High Speed Mode)

Features:

Two external analog telemetry ports (A1&A2) and one digital data-stream port (Rx);
When side port pins of A1 and X are connected by the jumper, A1 will change from external analog telemetry port to internal built-in battery voltage sensor;
RSSI (PWM) and CPPM output - If CH3 and CH4 are connected by a jumper, CH1 will output CPPM for CH1~CH8,
and CH2 will output RSSI (PWM);Convenient to upgrade – no need to open the receiver’s case when upgrading;
Firmware upgrade
Two switchable PPM modes - FS mode and HS mode;
Alarm warning on low voltage, poor reception, etc.

  

 

2.1 Bind procedure

1) Ascertain that the transmitter is in the PPM mode. Turn off the transmitter.

2) Turn on the transmitter while holding the F/S button on the transmitter module (Ensure that both switches on the transmitter module are OFF when using D8R-XP in two way mode). Release the button. The RED LED on the transmitter module will flash, indicating the transmitter is ready to bind to the receiver.

3) Connect battery to the receiver while holding the F/S button on the receiver. The RED LED on the receiver will flash, indicating the binding process is completed. Turn off both the transmitter and the receiver.

4) Turn on the transmitter and connect the battery to the receiver. The GREEN LED on the receiver will indicate the receiver is receiving commands from the transmitter. The receiver/transmitter module binding will not have to be repeated, unless one of the two is replaced.

 

2.2 Range check

A pre-flight range check should be done before each flying session. Reflections from nearby metal fences, concrete buildings or trees can cause loss of signal both during range check and during the flight.

The following steps are to be followed to perform the range check of the model before the flight:

1) Place the model at least 60cm (two feet) above non-metal contaminated ground (e.g. on a wooden bench).

2) The receiver antennas should be separated in the model, and do not touch the ground.

3) Place the antenna of the transmitter in a vertical position.

4) Turn on the transmitter and the receiver, press the F/S button of the transmitter module for 4 seconds to enter range check mode, the RED LED of the transmitter module will be off, GREEN LED will flash rapidly, and the beeper will sound. The effective distance will be decreased to 1/30 of full range.

5) Walk away from the model while simultaneously operating the controls on the transmitter, confirming that all controls operate normally to a distance of at least 30 meters (~30 yds).

6) Press the F/S button of the transmitter module for 1S-4S to exit range check mode, RED LED will be back on, indicating normal operation is back.

Warning: Battery or servos are NOT to be plugged into side ports (A1/A2/Rx), otherwise damage may occur.
Warning: HS mode is only applied for high-speed digital servos. Other servos should select FS mode, otherwise servos will get hot and may burn out.

This product was added to our catalog on Monday 06 May, 2013.
Reviews
Customers who bought this product also purchased
5.8 GHz RED <b> RP-SMA 90º </b> Cloverleaf Antenna Circular Pola
5.8 GHz RED RP-SMA 90º Cloverleaf Antenna Circular Pola
Minim OSD Micro (Clone)
Minim OSD Micro (Clone)
Silicone Wire Black 3 mm (12AWG)
Silicone Wire Black 3 mm (12AWG)
Mini  Servo MG90 PRO Small
Mini Servo MG90 PRO Small
Silicone Wire Red 3mm (12AWG)
Silicone Wire Red 3mm (12AWG)
Vortex Upgrade Metal Arm Mount Upgrade.
Vortex Upgrade Metal Arm Mount Upgrade.
Shopping Cart more
0 items
Manufacturer Info
Other products
Notifications more
NotificationsNotify me of updates to FRSKY D8R-XP. 8 two way comunication Ch8 RX 2.4Ghz W/ TELETRY, P
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
Tell A Friend
 
Tell someone you know about this product.
What's New? more
DJI Osmo Pocket - Extension Rod. Part 1
DJI Osmo Pocket - Extension Rod. Part 1
75.00EUR
Manufacturers
Languages
English Español
Currencies
Information
Financing
Shipping & Payment
Privacy
Conditions
Contact us
Site Map
RMA (Returns to SAT)

Copyright © 2019 ElectronicaRC.com
Powered by osCommerce

Shipping