FrSKY ACCST technology is proven, approved by many model associations, tested and reviewed as the leading Chinese 2.4Ghz R/C Technology. If you think DSM2 or FASST is the best, think again!
New FrSKY ACCST (Advanced Continuous Channel Shifting Technology) gives you secure radio communicatios in 2.4Ghz band. ACCST 2.4GHz system shifts 80 channels around hundred times per second in the 2.4GHz band. This means that the system is completely resistant to interference in that band.
The Two-way Radio System developed by FrSky provides an additional return link that would be used for monitoring the Rx’s voltage, temperature, location, speed and so on.
Advanced Continuous Channel Shifting Technology (ACCST is our advanced tecnology it shifts channel hundred times per second and there is no signal conflicts and interruptions) robust frequency agility.
Easy to bind and very fast link-up.
Excellent reboot time.
True Diversity with two antennas.
All channels can be programmed with Failsafe, quickly and easily.
Quick and extremely stable in performance.
Precise and smooth servo response.
Extended range (1.5km-2.5km).
FrSky DJT is compatible with JR and Turnigy transmitters following:
JR: 347, 388, 783, U8, PCM10, PCM10S, PCM10SX, PCM10IIS, 8103, J9303, PX, 9XII, 11XZERO
Turnigy: 9X, 9XR
Receiver Specification (D8R-II Plus):
Operating voltage: 3.5 - 10.0V
Power consumption: 100mA
Analog voltage: 0~3.3V
Number of channels: 8
Dimensions: 55 x 25 x 14 mm
Module specification DJT:
Operating voltage: 6.0V-13.0V (can handle 3S!)
Power consumption: 50mA
Output Power:: 60mW
Resolution: 3072 (11bit)
1 x 8-channel transmitter module DJT-II (V2)
1 x Transmitter Antenna
1 x 8-channel receiver D8R-II Plus
a) Two modes of transmission and reception between the receiver and the transmitter.
b) The receiver has two analog inputs which may be used to monitor the battery voltage, temperature sensor, etc., and transfer this data to the transmitter. You can configure the audible alarm when the output voltage is above or below the programmed level.
c) Receiver is able to accept serial data streams through a simple 3-wire RS232, information as GPS, altitude, so the data can be transferred to the transmitter without error, and sent to the RS232 port transmitter