Clone Minim OSD!!!

MinimOSD 1.1, a minimal Arduino-based on-screen display board. It's tailored for use with ArduPilot Mega, PixHawk and the MAVlink protocol, and designed to be as compact as possible. It's main components are an ATmega328P 8 bit microcontroller with an Arduino bootloader, and a MAX7456 monochrome on-screen display. Programming is done through an FTDI-compatible 6-pin header.

It features two independent power and ground sections to isolate the OSD's analog stage: a +5V section for the ATmega and the OSD's digital stage, powered through the FTDI cable or other +5V source; and a regulated +5V section for the OSD's analog stage, powered through the video in/out header and capable of handling up to +12V input. Solder jumpers are available to combine the two power and ground sections if desired.

Specifications:

•ATmega328P with Arduino bootloader
•MAX7456 monochrome on-screen display
•FTDI cable compatible pinout
•Standard 6-pin ISP header
•Two independent power sections with an LED indicator on each
•Solder jumpers for combining the power sections
•+5V 500mA regulator for up to +12V supply input
•Solder jumper for PAL video option
•Exposed test points for HSYNC and LOS<
•Dimensions: 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H (43x18mm
•Weight: 3 gr.

INCLUDED:

1x MinimOSD main board with case
12 Wire with connector

Manual

• Manual MinimOSD