- When use with Naze32 flight control, the LED can reflect the status of flight controller locked/ unlocked, left/ right aileron, brake, throttle, alarm etc.
- On-board 5V buzzer, you can enable it using a switch channel of your transmitter to locate the aircraft when needed.
Power supply: 5V ( 4-7V)
Dimension: 49 x 15 x 10mm
Fixing hole spacing: 44mm
Fixing hole diameter: 3mm
Supported flight controller: Arduino，Naze32，Skyline32，SPRacingF3 (CleanFlight firmware is needed)
Wiring guide (flight controls are NOT included):
Using with NAZE32